Sony FVS-1000 System Maintenance Manual page 29

(9) Set the air supply socket to the outside air supply tube, then connect the socket with the air supply
porthole of the air blow assembly.
n
Seal the air supply socket to the air supply porthole until the click can be heard.
When the outside air supply tube is 1/4 inch, it is possible to use the supplied air supply socket.
When the outside air supply tube is not 1/4 inch, use the air supply socket suitable to it.
Recommended socket : Nitto Industry Corporation, Hi-coupler socket (20 type, 30 type, 40 type)
Do not supply the outside air before completing the installation.
(10)Insert the drain assembly to the drain (one-touch joint) of the air blow assembly.
w
Be sure to connect the tube with the drain.
If no tube is connected, there is a case that the liquid is scattered, then enters eyes or stains clothes.
When the liquid enters eyes, clean the eyes in the clean water immediately, then consult a physician.
n
. Unnecessary water and oil which are included in the supplied air is drained from the drain. To
receive it, take some measures (placing the saucer etc.).
. Insert the tube completely, then confirm that it is not come out by pulling slightly.
. Do not set the draining tube higher than the drain.
There is a possibility that the water and oil flows backward from the drain.
. The length of the tube should be 5 m or less.
Air supply porthole
Air supply socket
Outside air supply tube
FVS-1000 MMP1
Hi-coupler socket (through which the outside air is supplied) has the auto-
matic opening and shutting bulb, so when the socket is pulled out, the air
supply is stopped.
Air blow assembly
Drain
Draining tube (ø4)
1-10. Installation Procedure
1-17