Sony FVS-1000 System Maintenance Manual page 101
Multi resolution film scanner, multi resolution telecine, telecine processor, telecine hdtv/sdtv processing boards, telecine log data processor, telecine 16 mm film adaptor kit, telecine optical kit, telecine mounted slide kit, telecine film sound process
Hide thumbs
Also See for FVS-1000 System:
- Operation manual (44 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
Rear view
Removal
1. Remove the 11 screws and remove the rear shield. (for UC/CE model only)
2. Loosen the two screws (with stopper) at the top and bottom of the board panel alternately.
3. Pull out the processor board from the guide rail.
Screws
Screws
Screws
Installation
4. Insert the processor board along the guide rail.
5. Tighten the upper and lower knobs one after the other several times, then insert the connector com-
pletely until the connector is connected.
n
Be sure to tighten the two screws one after the other.
If one screw is tightened completely first, there is a possibility of damaging the connector or screw.
6. Attach the rear shield with 11 screws.
FVS-1000 MMP1
Screws
Rear shield (for UC/CE model only)
2-8. Removing/Installing the Board
Screws (with stopper)
2-33
Advertisement
Table of Contents
