Sony FVS-1000 System Maintenance Manual page 192

4-10. Replacing the Processor Assembly
2. Removing the processor assembly
n
When removing the processor assembly from the
unit, be sure to perform the procedure by more
than two persons.
(1) Remove the four screws and trapezoid
washer.
(2) Remove the 11 screws and remove the rear
shield. (for UC/CE model only)
n
The processor assembly can not be pulled out
from the unit when the rear shield is attached.
When pulling out the processor assembly
from the unit, remove the rear shield.
(3) Holding the handle, pull out the processor
assembly to the front (5 cm).
(4) Disconnect the CN3 connector (rear) of the
processor assembly from the rear of the unit.
(5) Holding the handle on the side of the proces-
sor assembly, and remove from the unit.
Installation
3. Installing the processor assembly
(1) Push the processor assembly into the unit,
and connect the flexible card wire to the
connector CN3 (Rear) before 5 cm the
position connected completely.
n
Never mistake a connection of the connector.
If the connection connector is mistaken, it
becomes a system error and this machine
stops its operation.
(2) Push in the processor assembly completely.
n
Firmly push in the two power connectors of
the processor assembly to the connectors of
the unit.
(3) Secure the processor assembly with the four
screws and trapezoid washer.
(4) Attach the rear shield with 11 screws.
4. Installing the cables
Connect the cables removed in step 1, and install
the front cover.
4-26
Trapezoid
washer
RK5 x 14
Processor assembly
RK5 x 14
CN3
Power supply
connector
Handle
Trapezoid washer
Flat cable
FVS-1000 MMP1