Samsung NX-308 Programming & Installation Manual page 51

3. Enter new time (e.g. six (06) seconds)
4. Press CONF key to store and exit.
Default data : 04
MMC907 Dial Delay Time
This timer is used to select the waiting time after secondary network access code 131. This delay time
is used only when the call is routed to 131 network.
Action
1. Press CONF key and 907
2. Press MSG key
3. Enter new time (e.g. six (06) seconds)
4. Press CONF key
MMC908 Network Code
Provides secondary network access code when the call is routed to the secondary network. Maximum
of 16 entries, each 10 digits maximum in length.
Note: The second entry may be selected as a default secondary network (Mercury 132 Access). If
dialled digits are not matched to the entry in LCR Digit Table (MMC 901), and start with 0, the
network code in the second entry will be dialled out by the system prior to transmitting dialled digits.
Action
1. Press CONF key and 908
2. Press MSG key to make selection (00-15)
3. Enter the desired access via dial keypad (up to 10
digits)
4. Press CONF key to store and exit
(If you want to delete any item, press HOLD key in any state.)
Default data: 0:121 1:132
Related items: MMC901 LCR Digit Table
MMC902 LCR Route Table
MMC903 LCR Modify table
MMC909 PIN Code
Used to assign PIN code used when the call is routed to secondary 131 MCL network.
Action
2:161
04SEC:06
Display
DIAL DELAY TIME
05SEC:
05SEC:06
Display
NETWORK CODE
00:
00:12345
Display
49