Samsung NX-308 Programming & Installation Manual page 50

Assigns the LCR class of service allowed for a station on a per-station basis. There are eight classes
which may be assigned.
Action
1. Press CONF key and 904
2. Press MSG key to select station
3. Dial 0-7 to select class type
4. Press MSG key to continue
5. Press CONF key to store and exit
(If you want to delete any item, press HOLD key in any state.)
Default data : Class 0
MMC905 Assign PIN Code [Authorisation Code]
Assigns PIN codes to individual users. A maximum of four PIN codes are allocated by Mercury in the
system so users must be assigned to the PIN used when dialling out on a Mercury network. This MMC
is related only to 131 Mercury service.
Action
1. Press CONF key and 905
2. Press MSG key to select station
3. Enter the pin code serial number (0-3)
4. Press MSG key to continue
5. Press CONF key to store and exit
(If you want to delete any item, press HOLD key in any state.)
Default data : 0
Related items : MMC909 PIN Code
MMC906 LCR Inter Digit Time
This timer is used by LCR to determine when a station user has dialled the last digit of a number.
When LCR is enabled, each time a station dials a digit, this timer begins to count. If no other digit is
dialled before this timer expires, the call is considered complete and sent out on the route specified in
MMC902. The range of this timer is 00-99 seconds. The default is 04 seconds.
Action
1. Press CONF key and 906
2. Press MSG key
48
Display
LCR CLASS
21:CLASS 0 :
21:CLASS 0 :6
Display
ASSIGN PIN CODE
21:PIN CODE:
21:PIN CODE:1
Display
INTER DIGIT TIME
04SEC: