Samsung NX-308 Programming & Installation Manual page 31

# 10 Auto Answer Selection
See NX-308 Keyset User Guide.
# 11 Station Call Forwarding
See NX-308 Keyset User Guide.
# 17 Ringing Line Preference
See NX-308 Keyset User Guide.
# 20 Enable/Disable Technician Programming
Sets the system into programming enable or disable mode for technician-level access. This enables you
to access user programs also.
Press  key while on-hook.
1.
PROGRAMMING is displayed.
2. Dial 20.
MMC ENABLED or MMC DISABLED is displayed.
3. Enter password.
Default is 1234. If wrong password is entered, display shows ERROR and program mode
is not entered.
4. Dial 1 to enter program mode or make another selection as follows:
0: System program disable
1: System program enable
4: 12-hour clock
5: 24-hour clock
Press  key.
5.
Note: The system automatically leaves programming mode if no data is entered within four minutes.
# 21 Change Technician Password
(Does not require MMC enabled)
The technician's password can be changed as follows:
Press  key.
1.
PROGRAMMING is displayed.
2. Dial 21.
OLD PASSWORD is displayed.
3. Enter the current password.
NEW PASSWORD is displayed.
If the wrong password is entered, display will show ERROR and program mode is not
entered.
29