Station - Samsung NX-308 Programming & Installation Manual

1. Press # key.
PROGRAMMING is displayed.
2. Dial 51.
PBX FLASH TIME is displayed, then 'xxxx MSEC' is displayed.*
3. Enter four digits of new flash time.
4. Press # key.
(*The PBX line flash time (xxxx) ranges from 0 ms to 5000 ms (in 100 ms steps). If the entered data is
over 5000 ms, 5000 ms is entered into memory. Default is 100 ms.)
# 52 Hold / Camp-on Recall Time
Defines the length of time that a C.O. line is allowed to be on hold or camped-on before it recalls the

station.

1. Press # key.
PROGRAMMING is displayed.
2. Dial 52.
Display shows HOLD RECALL TIME followed by three digits.*
3. Enter three digits of new recall time.
4. Press # key.
(* The recall time ranges from 0 s to 200 s. A value of 200 s indicates that the timer setting is
indefinite, i.e. timer does not expire. Default is 30 s.)
Note: If the telephone is off-hook during the recall mode, the telephone will ring as soon as the
telephone goes on-hook.
# 53 Transfer Ring Time
Defines the length of time that a transferred call will ring at a station before it recalls the original
station.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 53.
Display shows TRSF RECALL TIME followed by three digits.*
3. Enter three digits of new transfer recall time.
4. Press # key.
(* The transfer recall time ranges from 0 s to 200 s. A value of 200 s indicates that the timer setting is
indefinite, i.e. timer does not expire. If the entered value is over 200 s, an error message is given.
Default is 30 s.)
# 54 Alarm Time Duration
39