Samsung NX-308 Programming & Installation Manual page 32

4. Enter new password.
Press  key.
5.
(Press HOLD key to clear entry and enter new data.)
Note: A 4-digit password is composed of any of 0-9 on the dial keys and 1-6 on the DSS keys. DSS
keys 1-6 represent A, B, C, D, E and F, respectively. Loss of RAM memory will reset the password to
default value 1234.
# 24 Software Version Display
(Does not require MMC enabled)
Provides a display of the current software version of the KSU and keyset.
Press  key.
1.
PROGRAMMING is displayed.
2. Dial 24.
VERSION is displayed.
3. Enter password.
Display shows KSU version and KTS version.
Press  key.
4.
# 25 System Initialisation
(Does not require MMC enabled)
Allows you to initialise the system without turning system power on and off.
Press  key.
1.
PROGRAMMING is displayed.
2. Dial 25.
INITIAL SYS? is displayed.
3. Enter password.
4. Enter one of three digits:
0 = No initialisation
1 = Initialisation of scratch pad data in RAM
2 = Initialisation of scratch pad data and battery backed-up data in RAM (takes
approximately 15 seconds)
Press  key.
5.
# 26 Night Mode Dialling Classes
Sets all stations to a specific call restriction class for after-hours service (Night Mode Operation).
1. Press # key.
PROGRAMMING is displayed.
30