Mitsubishi Electric Melsec Q Series User Manual page 129

7 ONLINE MODULE CHANGE
7 - 10
(2) Dismounting of module
(a) Take the following steps to disable the conversion:
1) Set A/D conversion enable/disable setting (buffer memory address 0:
Un\G0) to All channel conversion disable (FH).
2) Turn Operating condition setting request (Y9) from off to on to stop the
conversion.
3) Operating condition setting completed flag (X9) turns off from on.
4) Check that A/D conversion completed flag (buffer memory address
10: Un\G10) is in a status of Conversion stop (0H).
5) Turn Operating condition setting request (Y9) from on to off.
MELSEC-Q
7 - 10