Locating The Fuses; Drive System Maintenance; Adjusting The Transmission For Neutral - Toro Greensmaster TriFlex 3420 Operator's Manual

WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm. Wash
hands after handling.

Locating the Fuses

The fuses in the electrical system are located under
the seat (Figure 43).
Figure 43
1. Fuses
Fuse Layout
Optional Hydraulic
Fan Kit
15 A
Lights
Leak Detector
15 A
Run
10 A
g014803
Lift Reel
E-Reel Enable
7.5 A
Reel Engage
Lift/Lower
7.5 A
Start/Run
Diag. Lights
Leak Detector
7.5 A
ECM Logic
Power
2 A
42
Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction-control pedal
is in the N position, adjust the neutral-return
EUTRAL
mechanism.
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note:
If machine is equipped with a 3-Wheel
Drive Kit, also raise and block rear wheel.
2. Start the engine, move the throttle to the S
position, and ensure that the front wheel that is
off of the floor is not rotating.
3. If the wheel is rotating, shut off the engine and
proceed as follows:
A. Loosen the nut securing the eccentric to the
top of the hydrostat
Figure 44
1. Eccentric
B. Move the functional-control lever to the
N position and the throttle to the
EUTRAL
S position. Start the engine.
LOW
C. Rotate the eccentric until creep does not
occur in either direction. When the wheel
stops rotating, tighten the nut locking the
eccentric and the adjustment
Verify the adjustment with the throttle in the
S and F
LOW AST
Note:
If the wheel still turns when the
eccentric is at the maximum adjustment,
contact your Authorized Service Distributor
LOW
(Figure 44).
2. Locknut
(Figure 44).
position.
g014616