Chassis Maintenance; Checking The Tire Air Pressure; Checking The Machine For Loose Hardware; Cleaning - Toro GreensPro 1260 Operator's Manual

Chassis Maintenance

Checking the Tire Air
Pressure
1. Measure the air pressure in the tires of the
transport wheels.
You should measure 103 kPa (15 psi).
2. If the tire air pressure is higher than or lower than
103 kPa (15 psi), add air to or remove air from
the tires until you measure 103 kPa (15 psi).
Checking the Machine for
Loose Hardware
Service Interval: After the first 5 hours
Before each use or daily
Check the chassis for any loose or missing nuts and
bolts.
Tighten loose nuts and bolts and replace missing
hardware as required.

Cleaning

Cleaning the Machine

Service Interval: After each use
Important:
Do not use brackish or reclaimed
water to clean the machine.
1. Clean the machine with fresh water.
Note:
Do not use a pressure washer to clean
the machine.
2. Clean dirt and debris from the rollers as needed
by spraying water through the holes in the roller
housings (Figure
1. Access holes
3. Clean dirt and debris from the area around the
hydraulic motor
1. Hydraulic motor
4. Clean dirt and debris from the engine and the
engine-cooling fins
34
39).
Figure 39
(Figure 40).
Figure 40
(Figure 41).
g036889
g036788