Pre-Maintenance Procedures; Preparing For Maintenance; Raising The Operator's Seat - Toro GreensPro 1260 Operator's Manual

Pre-Maintenance
Procedures
Do not tilt the machine unless it is necessary. If you
tilt the machine, engine oil could enter the cylinder
head of the engine, and hydraulic fluid could leak from
the cap located on top of the tank. These leaks may
result in expensive repairs to the machine. To perform
service under the deck, lift the machine with a hoist or
a small crane.

Preparing for Maintenance

1. Drive or transport the machine to a level surface;
refer to Transporting the Machine (page
2. If lowered, raise the transport wheels; refer to
Raising the Machine onto the Transport Wheels
(page 16).
3. If the engine is running, shut off the engine.
4. Engage the parking brake.
5. If the engine is hot, wait for the engine and
hydraulic system to cool.

Raising the Operator's Seat

1. Pull back the seat latch until it clears the
seat-latch pin
16).
1. Seat latch
2. Tilt the seat forward
22
(Figure 23).
Figure 23
2. Seat-latch pin
(Figure 23).
g279773