Upgrading Your Voipu-S Firmware - NEC Aspire S Manual

Section 2: PCB Installation and Startup

Upgrading Your VOIPU-S Firmware

1.
2.
3.
4.
5.
6.
7.
8.
OR
Using an RS232 Connection:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Remove the CF card once the status LED1 on the VOIPU-S PCB starts flashing green.
11. Enter "slot info x" (x=the slot number) from HyperTerminal.
12. Confirm the version number.
13. Set the Load jumper (JP6) back to pins 1-2.
14. Set the SW3 switch on the Aspire S to the "4" side.
2-38 ◆ Section 2: PCB Installation and Startup
Copy the updated firmware file (VoIPU.bin) to the compact flash card.
Power down the system.
Insert the CF (compact flash) card into the VOIPU-S PCB's CN14 slot.
Move the Load jumper (JP6) to pins 2-3.
Insert the PCB into the cabinet.
Power up the system.
Remove the CF card once the status LED1 on the VOIPU-S PCB starts flashing green.
Set the Load jumper (JP6) back to pins 1-2.
Copy the updated firmware file (VoIPU.bin) to the compact flash card.
Power down the system.
Connect a PC to the serial connector (CN1) on the Aspire S using an RS232 cross cable.
Open HyperTerminal on the PC.
The settings for the HyperTerminal session should be:
Baud Rate: 38400, Data Bit: 8, Non Parity, Stop Bit: 1
Set the SW3 switch on the Aspire S CPU to the "6" side.
Insert the CF (compact flash) card into the VOIPU-S PCB's CN14 slot.
Move the Load jumper (JP6) to pins 2-3.
Insert the PCB into the cabinet.
Power up the system.
Aspire S Hardware Manual