Using The Psa-R Adapter - NEC Aspire S Manual

Section 4: Telephones and Optional Equipment
4.
5.
6.
7.
8.
9.
10. Move the handset cord from the keyset to the handset connector on the adapter.

Using the PSA-R Adapter:

1.
2.
3.
4.
4-48 ◆ Section 4: Telephones and Optional Equipment
Position the adapter with the connector positioned as shown below.
Figure 4-47: POSITIONING THE ADAPTER
Hook the two plastic prongs into the bottom of the phone.
Push the connector into place. The top latch on the top of the adapter should lock into place when it
is properly positioned.
Connect the line cord to the adapter.
This should be a PSTN, dedicated CO trunk.
Plug the LAN cable into the keyset.
If used, connect the AC adapter into the keyset.
This should always be done after connecting the LAN cable.
CAUTION: Before installing or removing the PSA-R adapter, be sure to first
remove the line cord, LAN cable, and then AC adapter from the outlet.
Placing Calls:
When the PSTN line has been activated either manually by the switch or due to a power failure, use
the dial pad buttons (0-9, *, #) to place an outside call.
Other than receiving calls, no other keyset functions are available.
Answering Calls:
When a call is received, the PSA-R adapter rings. If the LAN/PSTN Change Switch is set to PSTN,
answer the call by pickup up the handset. If the switch is set to the LAN position, answer the call by
changing the switch to PSTN and then pickup up the handset.
If you receive a call via PSTN during a conversation via LAN, answer the call by completing the
LAN call and placing the handset back into the cradle. Change the LAN/PSTN Change Switch to
PSTN and then lift the handset to answer the call. If you change the LAN/PSTN Change Switch to
the PSTN position while talking via LAN, the LAN call is disconnected.
Other than receiving calls, no other keyset functions are available.
Adjusting the Ring Volume
Use the Volume Control Switch located on the PSA-R adapter to adjust through the three available
volume levels.
Other than receiving calls, no other keyset functions are available.
When Power is Restored
The IP keyset restarts and reconnects to the network LAN. However, if you are on a PSTN call
when the power is restored, your conversation will continue until the handset is placed into the cra-
dle. Once this occurs, the IP keyset will restart and reconnect to the LAN.
Other than receiving calls, no other keyset functions are available.
Aspire S Hardware Manual