NEC Aspire S Manual page 175

Attaching the Belt Clip to the Handset
You can use the Belt Clip to attach the handset to your belt or pocket for convenient portability.
1. Slide the clip into the tab slot.
2. Press firmly until it snaps into place.
3. To remove, simply press the retaining clip in toward the Belt Clip and slide the clip up at the same
time.
Installing the Handset Battery
1. Remove the battery cover from the handset by pressing the latch and sliding the cover down
until it comes off the handset.
2. Slide the top of the battery into position, then lower the bottom portion into place. Note that the bat-
tery has positive and negative indications. With the Cordless II phone, make sure to place the bat-
tery in the handset so the negative is on the left and positive is on the right (the metal contacts
should face down toward the phone). With the Cordless Lite II phones, the battery pack cable must
be plugged into the handset.
3. Securely close the battery compartment cover by sliding it up until it snaps into place.
Charging the Handset Battery
The rechargeable battery pack must be fully charged before using your phone for the first time. Charge the
battery without interruption for 5 hours. The unique design of the telephone and charger allows you to place
the handset in the Desktop Charger with or without the Belt Clip attached.
1. Place the phone in the front slot of the desktop charger. The dial pad should be facing out in order
for the battery contacts to connect.
2. Make sure the CHARGE 1 LED lights. If the LED doesn't light, check to see that the AC adapter is
plugged in, and that the handset is making good contact with the battery contacts.
Aspire S Hardware Manual
Section 4: Telephones and Optional Equipment
CAUTION: The Belt Clip is designed to fit snugly onto the handset.
Figure 4-69: ATTACHING THE BELT CLIP
Figure 4-70: INSTALLING THE BATTERY
Section 4: Telephones and Optional Equipment ◆ 4-69
4