Led Indications - NEC Aspire S Manual

PCB Port Assignments
When installing a VoIP PCB, the system automatically assigns trunk ports to match the card's port capacity.
For example, a 4VOIPU-S would take 4 trunk ports, the 4VOIPU-S with a 4VOIPDB-S would take 8 trunk
ports. Extension ports are not reserved until an IP phone is connected to the system. When the first IP phone
is plugged in, the system takes the next four consecutive extension ports available and automatically assigns
them as IP ports. The next three IP phones installed will use this group of ports. When the fifth IP phone is
connected, the next 4 consecutive extension ports available will be assigned as IP ports.
If the number of trunk ports reserved by the system is a concern (as it could be with the Aspire S system),
install the trunk cards first, then install the VOIPU-S PCB. This will allow the trunks to be assigned to the
COIU-S, DIOPU-S, etc. first. If there are not enough trunk ports available for the VoIP PCB, the system will
still recognize the card and allow it to be used for IP phones.
Once a VoIP PCB has been installed in the system and trunks have been reserved for the PCB, the only way to
release the trunks for use by other PCBs is to remove the VoIP PCB and delete the slot (using Program 90-05).
For further details on using LAN devices, refer to Section 6: LAN Connection (page 6-1).

LED Indications

LED
LED1
PCB Status
LED2
DB RUN
LED3
RTP
Session
Status
LED4
PCMCIA
LED A
(On CN4)
LED B
(On CN4)
Aspire S Hardware Manual
Section 2: PCB Installation and Startup
LED
Function
Status
Status of PCB Green On
Green
Flashing
(slow flash)
Green
Flashing
(100ms
On/Off)
Green Off
Status of the Red
4VOIPDB
Off
Status of RTP Red
Session
Off
Status of PCMCIA Red
Slot
Off
Status of Link On
Data Transmission On
and Reception
Operation Status
Initializing or the Block
switch was set to the RUN
position.
Initialization problem
occurred during self-check.
Operating normally.
Downloading or the Block
switch was set to the BLK
position.
4VOIPDB-S is operating
normally.
4VOIPDB-S is not function-
ing correctly.
RTP session is established.
RTP session is not estab-
lished.
PC-ATA card installed.
PC-ATA card not installed.
Link is established.
Data is being transmitted or
received.
Section 2: PCB Installation and Startup ◆ 2-35
2
Comments
LED is on if one
of the channels is
established.