Table of Contents
Advertisement
Installing the Components in the Cabinet
1
Replace the air filters at the lower part and bottom of the front convex doors of the U32 enhanced device
with sponges.
Remove the lower beams of the front door panel. Pull the latch on the left side of the beam inwards until it
is out of the installation hole, and pull the beam outwards until the right-side small iron plate of the beam is
detached from the installation hole.
Remove the air filters at the lower part and bottom of the front and rear doors, and replace them with
sponge 1 and sponge 2 in packing box A. Before using sponge 1 and sponge 2, remove the release papers
from the adhesive areas, as shown in the following figure. Then, attach the sponges to corresponding
areas.
Re-install the lower beams. Insert the right-side small iron plate of the beam into the installation hole, push
the left side of the beam to align with the door panel, align the left side with the installation hole, and press
the latch for locking. When re-installing the lower beam, ensure that windshield sponge 1 is pressed by the
beam.
Latch
Beam
Windproof
sponge 1
Windproof
sponge 2
Small iron plate
NOTE
The dark gray areas are adhesive areas.
Before using them, remove release papers
first.
43
Rear cross section of sponge 1
Rear cross section of sponge 2
Hide quick links:
Advertisement
Table of Contents
