Figure 98. Connecting Link Cable (1); Table 28. Parts And Tools For Link Cable Connection - Samsung 5G NR Installation Manual

Interface Cable Connection
This section describes the procedures to connect the interface cables.
Connecting LINK Cable
To connect a LINK cable, do the following:
Prerequisites
Before proceeding with connecting the LINK cable, make sure that you have the
items mentioned in the table below:
Table 28. Parts and Tools for LINK Cable Connection
Category
Installation Section
Cable
Minimum Cable bend Radius
Connector
The light from the laser beam runs through the optical cable. Handle the optical
cables carefully, as the exposure to the laser beam can seriously injure worker's
eye.
1
Figure 98. Connecting LINK Cable (1)
[Bottom View]
2
5G NR HRU Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
Description
CDU to HRU L0, L1 Port
Optical Cable (Single Mode, for Outdoor Type)
10 × OD
HRU_LINK
CDU
Install the LINK cable from the CDU to the HRU L0, L1 port.
Separate the cap from the HRU/cables side connector.
MPO [JONHON, PAMPT1AM02-2 Plug]
DLC/UPC
LINK Cable
Confidential
Chapter 3 Connecting Cables
CDU
99