Fujitsu 1740 User Manual page 114

9
Mount the door on the rack and attach the stopper wire.
Mount the door on the rack while inserting the pin of the hinge assembly into the hole of the
upper hinge set component. Insert the pin into the upper and lower hinge set components
together. Be careful not to get your fingers caught in the gap between the door and rack.
Slide the lower hinge set component upward to insert the pin of the hinge assembly, and then
tighten the retaining screw to secure it in position.
Visually confirm that the gap between the hinge assembly and upper hinge set component is
the same as that between the hinge assembly and lower hinge set component.
If they are different, adjust the lower hinge set component or hinge assembly mounting
position.
Secure the stopper wire to the frame with an M5 hexagon head screw, and fully tighten the
screw for the door wire that was temporarily tightened.
Changing the position of the rotation axis of the rear door is completed.
'
Stopper wire
Pin of hinge assembly
(Two locations: upper and lower)
114
Tighten the screws to secure the stopper wire while keeping the door open with
the stopper wire stretched.
M5 hexagon head screw
Hinge assembly
Upper hinge
Lower hinge
Confirm the gap