4
Install the removed brackets in the rack.
Install the brackets, which were removed in step 3, on the side horizontally opposite the
standard side.
Secure the hinge assemblies with M5 screws and the rod receiving brackets with M5 flat head
screws.
Each screw is a self-tapping screw, which requires a certain degree of strength to tighten.
Confirm that the hinge assemblies and rod receiving brackets are installed correctly as shown
in "Normal state after installation."
'
Rod receiving bracket
(Three locations:
upper, center, lower)
(Normal state after installation)
100
M5 flat head screw
Hinge assembly
(Two locations:
upper and lower)
(Normal state after installation)
M5 screw