Huawei SUN2000-2KTL-L1 User Manual page 72

SUN2000-(2KTL-5KTL)-L1
User Manual
Figure 7-7 Grid-tied point control
Table 7-1 Grid-tied point control
Parameter Name
Active Unlimited
power
Grid
connection
with zero
power
Grid
connection
with
limited
power
(kW)
Issue 01 (2020-04-17)
Description
- If this parameter is set to Unlimited, the output power of the
SUN2000 is not limited and the SUN2000 can connect to the power
grid at the rated power.
Closed-loop 
controller

Total power indicates export limitation of the total power at the
Limitation mode
grid-tied point.
Power Specifies the shortest interval for a single anti-backfeeding
adjustment adjustment.
period
Power control Specifies the dead zone for adjusting the SUN2000 output power. If
hysteresis the power fluctuation is within the power control hysteresis, the
power is not adjusted.
Active power Specifies the derating value of the SUN2000 active power by
output limit for percentage. If the Smart Dongle does not detect any meter data or
fail-safe the communication between the Smart Dongle and the SUN2000 is
disconnected, the Smart Dongle delivers the derating value of the
SUN2000 active power by percentage.
Communication In the SUN2000 anti-backfeeding scenario, if this parameter is set to
disconnection Enable, the SUN2000 will derate according to the active power
fail-safe derating percentage when the communication between the SUN2000
and the Smart Dongle is disconnected for a period longer than
Communication disconnection detection time.
Communication Specifies the time for determining the communication disconnection
disconnection between the SUN2000 and the Dongle.
detection time
This parameter is displayed when Communication disconnection
fail-safe is set to Enable.

Closed-loop
controller

Limitation mode Total power indicates export limitation of the total power at the
grid-tied point.
Copyright © Huawei Technologies Co., Ltd.
If multiple SUN2000s are cascaded, set this parameter to
SDongle/SmartLogger.
If there is only one SUN2000, set this parameter to Inverter.
If multiple SUN2000s are cascaded, set this parameter to
SDongle/SmartLogger.
If there is only one SUN2000, set this parameter to Inverter.
7 Man-Machine Interaction
66