Saving Measurements In The Project; Exporting And Importing Measurements - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
5.3 Diagnostics via Startdrive
3. If required, activate the icon
4. Check to ensure that the signals (
You can display the signals via the shortcut menu.
Or:
1. In the
2. Double-click the selected measurement.
3. If required, activate the icon
4. Check to ensure that the signals (
You can display the signals via the shortcut menu.
Result
The recording is displayed in the "Diagram" tab.
5.3.2.7

Saving measurements in the project

Preconditions
● An online connection has been established to the drive.
● A recorded trace is saved in the drive.
● The data of the trace in the drive must of been displayed at least once in the curve
diagram. For display, the recorded data are loaded from the drive.
Procedure
To save a recording in the project, proceed as follows:
1. Open the trace in the drive with the recorded data (see Chapter "Creating or calling a
trace (Page 269)").
2. Ensure that the actual data from the drive are loaded by activating icon
3. After activating icon
4. Click on icon
The measurement is added to the
5. Save the project in Startdrive.
5.3.2.8

Exporting and importing measurements

Requirement
At least one measurement is in the "Measurements" system folder for export.
276
for monitoring.
"Measurements" system folder, select a measurement
for monitoring.
wait until all data have been loaded and displayed.
.
) are shown in the "Diagram" tab in the signal table.
) are shown in the "Diagram" tab in the signal table.
"measurement" system folder.
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
.
.
Commissioning with Startdrive