Siemens SINAMICS S120 Commissioning Manual page 13

Notation
The following notation and abbreviations are used in this documentation:
Notation for faults and alarms (examples):
• F12345
• A67890
• C23456
Notation for parameters (examples):
• p0918
• r1024
• p1070[1]
• p2098[1].3
• p0099[0...3]
• r0945[2](3)
• p0795.4
Use of OpenSSL
This product contains software (https://www.openssl.org/) that has been developed by the
OpenSSL project for use in the OpenSSL toolkit.
This product contains cryptographic software (mailto:eay@cryptsoft.com) created by Eric
Young.
This product contains software (mailto:eay@cryptsoft.com) developed by Eric Young.
Scope of the document
In this documentation, all the required steps for commissioning a SINAMICS S120 drive
system with Startdrive are explained in detail. Commissioning other systems which are also
based on the CU320-2 does not significantly differ to commissioning an S120 drive system.
Therefore, this Commissioning Manual can also be used for commissioning the following
SINAMICS drive systems:
● SINAMICS S150
● SINAMICS G130
● SINAMICS G150
● SINAMICS MV
● SINAMICS GL150
● SINAMICS SL150
● SINAMICS GM150
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Fault 12345
Alarm 67890
Safety message
Adjustable parameter 918
Display parameter 1024
Adjustable parameter 1070, index 1
Adjustable parameter 2098, index 1 bit 3
Adjustable parameter 99, indices 0 to 3
Display parameter 945, index 2 of drive object 3
Adjustable parameter 795, bit 4
Preface
11