Inserting And Specifying Motors From The Motor List - Siemens SINAMICS S120 Commissioning Manual

Commissioning
4.4 Creating a project offline in Startdrive
Preconditions
● A project has been created.
● The Control Unit is inserted in the device configuration.
● A Motor Module or a Power Module is inserted.
● An infeed is inserted.
Note
If you add the infeed unit at a later point in time, then you must manually wire the "infeed
unit" component with the other components.
● An encoder is inserted (optional).
4.4.7.1

Inserting and specifying motors from the motor list

Procedure
Proceed as follows to insert and specify motors in your device configuration:
1. Open "Motors" in the hardware catalog.
The following motor types are available for selection:
– DRIVE-CLiQ motors
– Induction motors
– Synchronous motors
– Reluctance motors
– Motor data input (motor data must be entered manually, see Chapter "Inserting and
2. Select the unspecified motor in the device overview.
3. Drag the unspecified motor to the lower area of the Motor Module.
4. Click the unspecified motor in the device view.
5. Open the Inspector window if it has still not been opened or displayed.
112
Note
For DRIVE-CLiQ motors, when loading the project data (see "Loading project data into
the drive (Page 202)") to the drive device, the motor and encoder data are
automatically read from the hardware being used. It is not possible (or necessary) to
specify the motor data at this point. However, for consistency reasons, after loading to
a drive device and reading from the hardware, ensure that the project data is again
transferred to the Startdrive project (see "Loading project data from a drive unit
(Page 71)").
specifying motors that are missing from the motor list (Page 113)").
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0