Huawei PDU8000 Series User Manual page 149

PDU8000 Modular Precision Power Distribution Cabinet
User Manual
Step 7 Open the rear door of the PDC, and remove all cables connected to the output modules.
Step 8 Remove connective screws from output module copper bars from the top down. This section
uses the third output module as an example.
Figure 8-19 Removing connective screws
Step 9 Assign two persons to remove the three output modules at the front of the PDC from the top
down.
Step 10 Removing the switch on the third output module: Push the black clip of the switch outwards
using a flat-head screwdriver as shown in
the inner side of the PDC, as shown in
output module.
Issue 02 (2016-11-10)
When removing cables, label the cables with corresponding terminal ports for later connection.
Figure 8-22
Mark the switches removed to ensure correct reinstallation.
Copyright © Huawei Technologies Co., Ltd.
Figure 8-20. Meanwhile, remove the switch along
Figure 8-21. Install the removed switch on the new
shows the recommended positions for installing the switch cables.
8 Maintenance Guide
142