Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 3500-D Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Lubricate all of the
bearings and bushings.
Every 500 hours/Yearly (whichever comes first)
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
washing.
The grease fitting locations and quantities are as
follows:
•
Rear cutting-unit pivot
Figure 32
•
Front cutting-unit pivot
Figure 33
•
2 sidewinder-cylinder ends
(Figure 32)
(Figure 33)
(Figure 34)
•
Steering pivot
g008894
•
2 rear lift-arm pivots and lift cylinder
g008895
37
Figure 34
(Figure 35)
Figure 35
(Figure
g008896
g195307
36)