Adjusting The Roller Scraper; Installing The Mulching Baffle - Toro Groundsmaster 3500-D Operator's Manual

8. Repeat steps 4 to
9. Tighten the 3 bolts to 41 N∙m (30 ft-lb).
Note:
Tighten the front bolt first.
Note:
Adjustments of more than 3.8 cm (1-1/2
inches) may require temporary assembly to an
intermediate height to prevent binding (e.g.,
changing from 3.1 to 7 cm (1-1/4 to 2-3/4 inches)
height of cut).
8
Adjusting the Roller
Scraper
Optional
No Parts Required
Procedure
The optional rear roller scraper works best when there
is an even gap of 0.5 to 1 mm (0.02 to 0.04 inch)
between the scraper and the roller.
1. Loosen the grease fitting and the mounting
screw (Figure 18).
Figure 18
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until you obtain a
gap of 0.5 to 1 mm (0.02 to 0.04 inch) between
the rod and the roller.
3. Tighten the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
7 for each side adjustment.
3. Grease fitting
9
Installing the Mulching
Baffle
Optional
No Parts Required
Procedure
1. Thoroughly clean debris from the mounting holes
on the rear wall and left wall of the chamber.
2. Install the mulching baffle in the rear opening
and secure it with 5 flange-head bolts
19).
1. Mulching baffle
3. Verify that mulching baffle does not interfere with
g031578
the tip of the blade and does not protrude inside
the surface of the rear chamber wall.
17
(Figure
Figure 19
2. Flange-head bolt
g031579