Changing The Hydraulic Filter - Toro Groundsmaster 3500-D Operator's Manual

4. Remove the dipstick from the filler neck and
wipe it with a clean rag.
5. Insert the dipstick into the filler neck, then
remove it and check the fluid level.
Note:
The fluid level should be within 6 mm
(1/4 inch) of the mark on the dipstick.
6. If the level is low, add the appropriate fluid to
raise the level to the F
7. Install the dipstick and cap onto the filler neck.
Changing the Hydraulic
Filter
Service Interval: After the first 10 hours
Every 200 hours/Yearly (whichever comes first)
Use a genuine Toro replacement filter (Part No.
86-3010).
Important:
Using any other filter may void the
warranty on some components.
1. Perform the pre-maintenance procedure; refer
to Preparing the Machine for Maintenance (page
36).
2. Pinch off the hose to the filter-mounting plate.
3. Clean around the filter-mounting area, place a
drain pan under the filter, and remove the filter
(Figure 63).
1. Hydraulic filter
4. Lubricate the new filter gasket and fill the filter
with hydraulic fluid.
5. Ensure that the filter mounting area is clean and
screw the filter on until the gasket contacts the
mounting plate; then tighten the filter 1/2 turn.
mark.
ULL
Figure 63
6. Release the hose to the filter-mounting plate.
7. Start the engine and let it run for approximately
2 minutes to purge air from the system.
8. Shut off the engine and check for leaks.
g195308
51