E516-0002-02 Paddle Motor Error (Finisher-K1); E530-8001-02: A. Rear Alignment Motor Error (Finisher-K1) B. Front Aligning Plate Hp Error (Finisher-Aa1) - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E516-0002-02
Detection Description
Remedy
E530-8001-02
Detection Description
Remedy
Paddle Motor error (Finisher-K1)
- The Paper Fold HP Sensor was not turned ON although 3 seconds had passed after the Paddle
Motor operation started.
- The last paper fold operation is not finished when driving the Paddle Motor.
INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Paper Fold HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Paddle Motor
- Paper Fold HP Sensor (PS8)
- Paddle Motor (M10)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
a. Rear Alignment Motor error (Finisher-K1) b. Front Aligning Plate HP error (Finisher-AA1)
a. The Rear Alignment Plate HP Sensor was not turned OFF although 1 second had passed after
the Rear Alignment Motor operation started.
b. The front aligning plate does not come off the Front Aligning Plate HP Sensor although the Front
Aligning Plate Motor has been driven for 4 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Alignment Motor
- Rear Alignment Plate HP Sensor (PS5)
- Rear Alignment Motor (M4)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Aligning Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Aligning Plate Motor
- Front aligning plate drive mechanism
- Front Aligning Plate HP Sensor (PI106)
- Front Aligning Plate Motor (M103)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
393
7. Error/Jam/Alarm