Error Code; E001-0001-05 Fixing Main Thermistor High Temperature Detection Error; E001-0002-05 Fixing Sub Thermistor (Front) High Temperature Detection Error; E001-0003-05 Fixing Sub Thermistor (Rear) High Temperature Detection Error - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

Error Code

E001-0001-05
Detection Description
Remedy
E001-0002-05
Detection Description
Remedy
E001-0003-05
Detection Description
Remedy
Fixing Main Thermistor high temperature detection error
The Fixing Main Thermistor detected a high temperature error.
[Related parts]
- Harness between the DC Controller PCB and the Fixing Unit
- Harness between the DC Controller PCB (J115) and the AC Driver PCB (J505)
- Harness between the AC Driver PCB and the Fixing Unit
- Fixing Unit
- Fixing Drive Unit
- DC Controller PCB
- Power Supply Unit
- Fixing Motor (M09)
[Remedy] Check/replace the related harness/cable, connector and parts.
After performing the remedy work, go through the following to clear the error: COPIER>
FUNCTION> CLEAR> ERR.
[Reference] Before replacing the DC Controller PCB, back up the service mode data and restore
the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Fixing Sub Thermistor (Front) high temperature detection error
The Fixing Sub Thermistor (Front) detected a high temperature error.
[Related parts]
- Harness between the DC Controller PCB and the Fixing Unit
- Harness between the DC Controller PCB (J115) and the AC Driver PCB (J505)
- Harness between the AC Driver PCB and the Fixing Unit
- Fixing Unit
- Fixing Drive Unit
- DC Controller PCB
- Power Supply Unit
- Fixing Motor (M09)
[Remedy] Check/replace the related harness/cable, connector and parts.
After performing the remedy work, go through the following to clear the error: COPIER>
FUNCTION> CLEAR> ERR.
[Reference] Before replacing the DC Controller PCB, back up the service mode data and restore
the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Fixing Sub Thermistor (Rear) high temperature detection error
The Fixing Sub Thermistor (Rear) detected a high temperature error.
[Related parts]
- Harness between the DC Controller PCB and the Fixing Unit
- Harness between the DC Controller PCB (J115) and the AC Driver PCB (J505)
- Harness between the AC Driver PCB and the Fixing Unit
- Fixing Unit
- Fixing Drive Unit
- DC Controller PCB
- Power Supply Unit
- Fixing Motor (M09)
[Remedy] Check/replace the related harness/cable, connector and parts.
After performing the remedy work, go through the following to clear the error: COPIER>
FUNCTION> CLEAR> ERR.
[Reference] Before replacing the DC Controller PCB, back up the service mode data and restore
the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
328
7. Error/Jam/Alarm