Mitsubishi Electric MELSEC iQ-R Series User Manual page 167

Attribute Access
(: Available, :
ID
Not available)
Get Set
5  
6  
7  
 
8
 
9
 
11
Name
Media Alignment Errors
Counters
FCS Errors
Single Collisions
Multiple Collisions
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
MAC Transmit Errors
Carrier Sense Errors
Frame Too Long
MAC Receive Errors
Interface Control Bits
Control
Forced Interface Speed
Interface Type
Interface State
Admin State
Interface Capability Bits
Capability
Speed/ Speed/Duplex
Duplex Array Count
Options
Speed/ Interface
Duplex Speed
Array
Interface
Duplex
Mode
Appendix 4 Details of Message Communication Support Command
Data Description
type
UDINT Number of receive frames with lengths
that are not octet integers
UDINT Number of receive frames that do not
pass the FCS check
UDINT Number of frames sent successfully
with only one collision
UDINT Number of frames sent successfully
with two or more collisions
UDINT Number of times SQE test error
messages were created
UDINT Number of frames for which the first
transmission test was delayed due to
the medium being busy
UDINT Number of collisions detected in packet
transmission after 512 bit time or later
in packet transmission
UDINT Number of failed frames in transmission
due to excessive collisions
UDINT Number of frames that failed to be
transmitted due to internal MAC
sublayer transmission errors
UDINT Number of times the carrier sense
condition was lost or was not asserted
during attempts to send frames
UDINT Number of receive frames that
exceeded the maximum allowable
frame size
UDINT Number of frames that failed to be
received through interface due to
internal MAC sublayer receiving errors
WORD Interface control bits
UINT Forced interface operation speed
USINT Interface type
USINT Current interface status
USINT Current administration status
DWORD Interface function other than Speed/
Duplex
USINT Number of Speed/Duplex arrays
UINT Speed to force the interface to operate
at
USINT Duplex mode of the interface
Setting value
(Set)/stored
value (Get)
Value on the left
Value on the left
Value on the left
Value on the left
0
Value on the left
Value on the left
Value on the left
Value on the left
Value on the left
Value on the left
Value on the left
0001H
0000H
02H
01H
01H
00000007H
06H
10, 10, 100,
100, 1000, 1000
*1
0, 1, 0, 1, 0, 1
APPX
165
A