Requirement For The Compliance With Emc And Low Voltage Directives - Mitsubishi Electric MELSEC iQ-R Series User Manual

Section 9 REQUIREMENT FOR THE COMPLIANCE WITH EMC AND LOW VOLTAGE DIRECTIVES
Section 9 REQUIREMENT FOR THE COMPLIANCE WITH EMC AND
LOW VOLTAGE DIRECTIVES
(1) For programmable controller system
To configure a system meeting the requirements of the EMC and Low Voltage Directives when incorporating
the Mitsubishi programmable controller (EMC and Low Voltage Directives compliant) into other machinery
or equipment, refer to "MELSEC iQ-R Module Configuration Manual".
The CE mark, indicating compliance with the EMC and Low Voltage Directives, is printed on the rating plate
of the programmable controller.
(2) For the module
For the compliance of this module with the EMC and Low Voltage Directives, refer to "6.3 Wiring".
(3) CE marking conformity combination module
This module conforms to CE marking standard in a condition to make combination use with following current
censor and cable.
Current sensor
Cable or
current sensor cable
Max. cable length
EMU-CT50，EMU-CT100，EMU-CT250，
EMU-CT400-A，EMU-CT600-A
CE marking cable (twisted pair cable)
Single wire : AWG24 - 16 (φ 0.52 - 1.29mm)
Stranded wire : AWG20 - 16 (0.52 - 1.30mm
50m
)
2
143
RE81WH
EMU2-CT5
EMU2-CB-Q5A,
EMU2-T1M, EMU2-T5M,
EMU2-T10M, EMU2-T1MS,
EMU2-T5MS, EMU2-T10MS
11m