Change Units Password; Print Configuration - Philips M3150B Installation And Service Manual

Troubleshooting
If transfer time is determined to be too long, adjust the Bandwidth Utilization setting to try
to shorten the time period. This change takes 3-5 seconds and can be done while monitoring.
Decreasing the time period of the data transfer will increase the bandwidth utilization of the
hospital LAN, which may be undesirable.
Table 7-10. Patient Data Transfer - Bandwidth Utilization
Hospital Infrastructure
Topology
Pure 100 Mbit Hospital LAN
Mixed 10/100 Mbit Hospital LAN
Note Patient Data Transfer durations are estimates. Actual time on a hospital network will vary
depending on the design of the network and the level of network bandwidth that is available.
Change Units
Changes the Unit settings password. This is available on Database servers and M3150 Local
Password Database Information Centers only.
Print Opens the Printer dialog box to delete a print jobs in the queue or a stuck print job while the
Configuration
devices are in monitoring mode. This is not to be used to add or delete printers! Adding and
deleting printers must be done via the Network Configuration page of the Config Wizard.
7-76
Maintenance, Troubleshooting, and Repair
Peak Bandwidth
Utilization (Average)
72 Mbps
32 Mbps (avg)
56 Mbps
30 Mbps (avg)
32 Mbps
8 Mbps (avg)
8 Mbps
8 Mbps (avg)
8 Mbps
6 Mbps (avg)
8 Mbps
4 Mbps (avg)
Patient Data Transfer
Duration
1-2 minutes
3-5 minutes
10-15 minutes
6-8 minutes
10-12 minutes
15-20 minutes
Bandwidth Utilization
Setting
High
Medium
Low
High
Medium
Low