Mitsubishi Electric M80 Series Maintenance Manual page 207

Date of revision Manual No.
Mar. 2017 IB(NA)1501273-C
Nov. 2017 IB(NA)1501273-D
The contents were corrected to correspond with the system software C3 ver-
sion.
Added the following chapters:
- 1.4.5.3 EtherNet/IP
- 4.4.1.1 Displaying the PLC Device Data
- 4.4.1.2 Carrying Out Modal Output
- 4.4.1.3 Carrying Out One-shot Output
- 4.12 Application Error Detection
- 4.13 IP Address Resetting Procedure at Disabled Network Communication
[M800W/M80W Series Only]
- 6.13 MITSUBISHI CNC Machine Operation Panel
Reviewed the contents in the following chapters:
- 1.1 System Basic Configuration Drawing
- 1.2 General Connection Diagram
- 1.4.1 Control Unit
- 1.4.4 Remote I/O Unit
- 2.2.2 List of Replacing Parts
- 2.2.4 Replacing Fuse
- 4.5.1 Self Diagnosis Screen
- 4.7.1 Servo Unit
- 4.7.2 Spindle Unit
- 4.7.3 Power Supply Unit
- 4.11 Diagnosis Data Collection Setting
- 6.1 Data Backup and Restoration
- 6.2 Control Unit
- 6.7 Remote I/O Unit
Also, corrected wrong indications.
The descriptions were revised corresponding to S/W version C7 of Mitsubishi
CNC M800/M80 series.
Changed the contents in the following chapters:
- 1.3.1 System Configuration Screen
- 3.3.2.2 Replacing the Unit Fan
- 4.5.1 Self Diagnosis Screen
- 4.9.2 Signal Monitor Screen
- 4.9.4 Version Display Screen
- 4.11 Diagnosis Data Collection
- 6.13 MITSUBISHI CNC Machine Operation Panel
Also, corrected wrong indications.
Revision details