GE MDS 4790 Series Installation & Operation Manual page 93

MDS 05-3438A01, Rev. F
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
4. Use the and
DLINK ON
enable network-wide diagnostics and set the baud rate at the
port of each node radio.
NOSTICS
5. Connect same-site radios using a null-modem cable at the radios'
ports.
DIAGNOSTICS
6. Connect a PC on which MDS InSite software is installed to the root
radio, or to one of the nodes, at the radio's
PC can be the PC that collects payload data, as shown in
To connect a PC to the radio's
DB-9 adapter (MDS P/N 03-3246A01) is required. If desired, you
can construct an adapter cable from scratch using the information
shown in Figure 38 on Page
7. Launch the MDS InSite software at the PC. See the InSite Radio
System Management Software User's Guide for instructions.
DTYPE
NODE
R TU
DTYPE
ROOT
MASTER STATION
ROOT
DIAGNOSTICS DATA
(TO InSite)
Figure 37. Network-Wide Remote Diagnostics Setup
MDS 4790/9790 Series I/O Guide
commands to
DLINK [baud rate]
DIAGNOSTICS
port, an RJ-11 to
DIAGNOSTICS
86.
Invisible place holder
R TU
DTYPE
NODE
R TU
TO DATA
TO
PORT
DIAGNOSTICS
PORT
PAYLOAD DATA
(TO SCADA APPLICATION)
HOST COMPUTER
DIAG-
port (this
Figure 37).
DTYPE
NODE
85