Table of Contents
Advertisement
Data Interface Baud
Rate
Data Interface
Buffering
42
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
BAUD [xxxxx abc]
The
command displays or sets the communication attributes for
BAUD
the
port. The command has no effect on the RJ-11
DATA INTERFACE
(nostics) port.
DIAG
Entering the
command alone displays the baud rate along with
BAUD
asynchronous data attributes. Entering the
one or more parameters resets the data port attributes.
BAUD xxxxx abc
Example:
BAUD 4800 8N1
The first parameter,
xxxxx
bits-per-second, and must be one of the following rates: 110, 300, 1200,
2400, 4800, 9600, 19200, or 38400.
The second parameter of the
ifying asynchronous data attributes:
= Data bits (
or
a
7
= Parity (
for None,
b
N
= Stop bits (
or
c
1
The factory default setting is 9600 baud, 8 data bits, no parity, 1 stop bit.
NOTE:
,
, and
7N1
8O2
8E2
If the data rate is faster than the radio's baud rate setting, the
accepts a minimum of 500 data bytes in a single continuous data trans-
mission. At baud rates of 9600 bps or less, the radio supports unlimited
continuous data transmission. Under this condition, the
shaking (CTS) would keep toggling on/off for a long transmission, or
the buffer might be able to absorb a smaller amount of data. Avoid
mis-matched data rates whenever possible.
BUFF [ON/OFF]
This command displays or sets the received data handling mode.
Entering the
command alone shows whether the mode is seamless
BUFF
(
), or fast byte throughput (
ON
lowed by a parameter resets the received data handling mode. The
parameter sets the radio to seamless data mode. The
the radio to fast byte throughput mode. The default is seamless data
mode.
MDS 4790/9790 Series I/O Guide
Baud Rate/Format
A
B
Page 70
command followed by
BAUD
, is the baud rate. Baud rate is specified in
command is a 3-character block spec-
BAUD
)
8
for Odd,
for Even)
O
E
)
2
are invalid communication settings.
Data Buffering
A
B
). Entering the
OFF
BUFF
MDS 05-3438A01, Rev. F
screen,
Port
DATA
Port hand-
DATA
screen,
Page 74
command fol-
ON
parameter sets
OFF
Hide quick links:
Advertisement
Table of Contents
