Rxlevel [-20 To +3]; Rxmute [On/Off/Time In Msec]; Rxpad [On/Off]; Rxtot [None, 1-1440] - GE MDS 4790 Series Installation & Operation Manual

Received Data Audio
Level
Receiver Muting
Receive Data
Attenuator
Receiver
Timeout-Timer
MDS 05-3438A01, Rev. F
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
RXLEVEL [–20 to +3]
A
B
The and
RXLEVEL TXLEVEL
settings when the radio is operating in analog mode. When used alone,
the command displays the receive level in dBm. Entering the
RXLEVEL
command followed by a number from
RXLEVEL
audio level in dBm.
NOTE: The
and
RXLEVEL
"A"/analog model radios.

RXMUTE [ON/OFF/Time in msec]

Use this command to set or display the radio's receive (RX) muting
status. Receive muting might be required when you configure the radio
as a full-duplex polling remote communicating through a repeater. It
prevents the radio from hearing its own transmissions ("echoes") from
the repeater, which might cause software application errors.
Entering the command without a parameter shows whether the
RXMUTE
muting feature is (enabled) or
ON
command followed by
ON
After issuing the
RXMUTE ON
muting time. Use the
RXMUTE nn
seconds. This causes the receive muting feature to assert for nn millisec-
onds following the end of a transmission.

RXPAD [ON/OFF]

This command enables or disables the receive attenuator for the receive
audio level on radios operating in the analog mode. Entering the
command without a parameter shows whether the attenuator is
(enabled) or (disabled). Entering the
OFF
enables the receive attenuator; entering
ON

RXTOT [NONE, 1-1440]

The command selects or displays the receive timeout timer value
RXTOT
in minutes if the receiver fails in a way that generates no other alarms
(for example, if data is not detected within the specified time). This
timer triggers an alarm (event 12) and forces a switch-over to the
standby transceiver board.
MDS 4790/9790 Series I/O Guide
Receive Level [–20 to +3] screen
Page 75
(Page 59) commands control the audio level
20 to +3 resets the
–
commands are only available on the
TXLEVEL
RX Mute Mode
A
B
Page 69
(disabled). Entering the
OFF
enables muting; entering
command, you can specify a receive
command, where
Receive Pad
A
B
command followed by
RXPAD
disables it.
OFF
screen,
RXMUTE
disables it.
OFF
is a time in milli-
nn
screen, Page 75
RXPAD
ON
53