GE MDS 4790 Series Installation & Operation Manual page 43

MDS 05-3438A01, Rev. F
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
Table 7. PC Commands—Radio Operation (Continued)
TERMINAL FRONT
COMMAND PANEL MENU
RX [xxx] Receive Frequency
Details, page 52 Details, page 69
RXLEVEL [–20 to +3] Receive Level [–20 to
Details, page 53 +3]
Details, page 75
RXPAD [ON/OFF] Receive Pad
Details, page 53 Details, page 75
RXTOT [NONE, 1-1440] RX Timeout [NONE,
Details, page 53 1-1440]
Details, page 71
SCD [0-255] Transmit Timeout
Details, page 54 Details, page 71
TIME [hh:mm:ss] Set Time
Details, page 57 Details, page 77
TOT [ON/OFF, 1-255] Transmit Timeout
Details, page 58 Details, page 71,
Transmit Timeout Dura-
tion
Details, page 71
TX [xxxx] Transmit Frequency
Details, page 58 Details, page 68
TXGAIN [ON/OFF] Transmit Gain
Details, page 59 Details, page 75
TXLEVEL [–20 to +3, Transmit Level [–20 to
AUTO] +3, AUTO]
Details, page 59 Details, page 74
Table 8. PC Commands—Diagnostics
FRONT
PC COMMAND PANEL MENU
ALARM Active Radio Status
Details, page 37 Details, page 77
AMASK [0000 Alarm Masks
0000–FFFF FFFF] Details, page 75
Details, page 40
NMASK [0000 None
0000–FFFF FFFF]
Details, page 49
ASENSE [HI/LO] None
Details, page 41
LOG [CLR] Event Log
Details, page 48 Details, page 79
Clear Logs
Details, page 79
DLINK [ON/OFF/xxxx] None
Details, page 45
DTYPE None
[NODE/ROOT/GATE/PE
ER]
Details, page 46
KEY Manual Key
Details, page 47 Details, page 72
MDS 4790/9790 Series I/O Guide
DESCRIPTION
Set or display receive frequency
Set or display the analog audio receive level in
dBm
Enable or disable RX pad
Set or display the receiver timeout timer
Set or display the soft-carrier dekey delay
Set or display the current time
Set or display the timeout timer delay
Set or display the transmit frequency
Enable or disable TX gain
Set or display the analog audio transmit level in
dBm
DESCRIPTION
Display current alarm status in hexadecimal
format
Set or display the major alarm mask
Set or display the minor alarm mask
Set or display the sense of the alarm bits
(active high or active low)
Display or clear the event log
Enable or disable network-wide diagnostics
and set the baud rate at the RJ-11 DIAG port
Set up a radio as a root, node, gate, or peer
radio
Enable the transmitter
35