Dtype [Node/Root/Gate/Peer]; Emp [On/Off]; Hrev; Init - GE MDS 4790 Series Installation & Operation Manual

400 mhz/900 mhz multiple address system master station radio
Table of Contents

Advertisement

Unit Diagnostic
Service
TX & RX Emphasis
Hardware Revision
Level
Initialize to Factory
Defaults
46
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx

DTYPE [NODE/ROOT/GATE/PEER]

This command configures a radio's type for network-wide diagnostics.
For most radio systems, it is sufficient to define a radio as a root or node
radio. The root radio is the radio connected to the host computer for
non-intrusive diagnostics functions. Specify only one root per radio net-
work.
The
and
settings are used for complex radio networks and are
GATE
PEER
included to accommodate network-wide diagnostics in simplex and spe-
cial radio network configurations.
Entering
configures the radio as a node radio. Entering
DTYPE NODE
configures the radio as a root radio. Entering the
ROOT
displays the current setting. The default setting is
Refer to
Section 7.2, Performing Network-Wide Radio Diagnostics,
beginning on Page
84. Refer to the GE MDS Network-wide Diagnostics
Handbook (P/N 05-3467A01) for a complete explanation of remote
diagnostics.

EMP [ON/OFF]

Use this command to enable or disable pre-emphasis and de-emphasis
on the analog input and output signals.
Pre-emphasis is a function used in older analog radios where the trans-
mitter's modulating signal is increased at the higher frequencies to
increase system performance. De-emphasis compensates at the receiver
for a transmitted signal that has had pre-emphasis applied.
indicates that pre-emphasis and de-emphasis are enabled, and
ON
indicates that pre-emphasis and de-emphasis are disabled.

HREV

This command displays the hardware revision level.

INIT

This command resets customer-programmable settings back to factory
defaults:
Table 12. Defaults for User-Configurable Parameters
Function
Alarm Mask—Major (AMASK)
Alarm Mask—Minor (NMASK)
Alarm Sense—(ASENSE)
Buffer Mode
MDS 4790/9790 Series I/O Guide
NODE
Emphasis
A
B
Value
FFFF 0000
0000 FFFF
Active Open (High)
On
MDS 05-3438A01, Rev. F
DTYPE
command alone
DTYPE
.
screen,
Page 70
OFF

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents