ABB ACS355 Manual page 38

38 Actual signals and parameters
Actual signals
No. Name/Value
0185 CUMULA YEAR
FLOW
03 FB ACTUAL SIGNALS
0310 SOLAR STS WORD1
Bit Name
0 RDY_ON
1 RDY_ REF
2 RUNNING
3 FAULT
4 DRY_RUN
5 DC_OVERVOLT
6 DC_UNDERVOLT
7 PUMP_MINIMUM_SPEED 1
8 SHORT_CIRC
9 EARTH_FAULT
10 MOTOR_PHASE
Description
Shows the measured flow of current year in cubic
decameter. The value displayed is the measured
flow from first day to current day of the year.
Note: You can reset this value using
FLOW.
Data words for monitoring the fieldbus
communication (read-only). Each signal is a 16-bit
data word. Data words are displayed on the panel
in hexadecimal format.
A 16-bit data word.
Value Status
1 Ready to switch on.
0 Not ready to switch on.
1 Operation enabled.
0 Operation inhibited.
1 Drive is modulating.
0 Drive is not modulating.
1 Drive is in fault state.
0 Drive is not in a fault state.
1 Dry run fault is detected.
0 No dry run fault.
1 Excessive intermediate circuit DC voltage
detected.
0 No excessive intermediate circuit DC
voltage.
1 Intermediate circuit DC voltage is not
sufficient.
0 Intermediate circuit DC voltage is sufficient.
Minimum speed alarm is active.
0 Minimum speed alarm is not active.
1 Short circuit in motor cable(s), motor or
internal fault of the drive.
0 No short circuit.
1 Earth (ground) fault in motor or motor cable
detected by drive.
0 No earth (ground) fault.
1 Motor circuit fault due to missing motor
phase.
0 No motor circuit fault.
FbEq
1 = 1 m
6131 RESET
1 = 1
6