Step-3 Initial Settings For The Bacnet; Related Items - Mitsubishi Electric AE-200A Instruction Book

7-5. Step-3 Initial settings for the BACnet

Make the initial settings related to BACnet
Step-3
HUB
Setting PC
Other
AE-200/AE-50/EW-50
(1) Data setting
®
LAN2 (BACnet
has been installed on the Setting PC. Because the BACnet
AE-200/AE-50/EW-50 at one time, even when the system is configured with multiple AE-200/AE-50/EW-50
units, it is necessary to configure each AE-200/AE-50/EW-50 unit.
The setting items are as follows. (Refer to the AE-200/AE-50/EW-50 Instruction Book (BACnet
for details for each of the items.)
① LAN2 (BACnet
Settings are made for the IP address, subnet mask, and default gateway of LAN2 (BACnet
AE-200/AE-50/EW-50.
No. Main tab
1 System Settings
Important
When the IP address of AE-200/AE-50/EW-50 overlaps the IP address of another unit inside the network,
not only can AE-200/AE-50/EW-50 not carry out BACnet
cannot carry out BACnet
check the IP address used on AE-200/AE-50/EW-50 and make settings.
®
② BACnet related settings
Settings are made for the device No. of AE-200/AE-50/EW-50, the notification destination and whether or
not an object is used.
No. Main tab
1
2
3
BACnet Settings
4
5
6
WT07919X04
®
HUB
BACnet
M-NET
LAN1
AE-200/
Outdoor
AE-50/EW-50
unit
Outdoor
unit
®
) settings and BACnet
®
) settings
Basic Settings
®
communication normally. Before connecting AE-200/AE-50/EW-50 to BACnet
BACnet
Network and Device
COV Notification
Event Notification
Object
Other
®

related items

®
using the BACnet Setting Tool.
Building management system
HUB
®
M-NET
Indoor unit
ME remote controller
M-NET
Indoor unit
ME remote controller
related settings are made using the BACnet
®
Setting Tool can only configure single
Sub tab
®
communication normally but other devices also
Sub tab
41
LOSSNAY
LOSSNAY
®
Setting Tool which
®
Setting Tool)
®
) of the
®
,