Fitting The Cover Plate; Table 42 Tightening Torque (51007) - ABB TPS48-H33 Operation Manual

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
10 Taking out of operation at short notice
10.4

Fitting the cover plate

Gas outlet casing
The turbocharger must be removed from the engine for the assembly of the
cover plate. To save time in the event of an emergency repair, the gas outlet
NOTICE
casing (61001) can stay fitted on the exhaust gas pipe.
Remove turbocharger (see chapter Removing and Installing [➙ 11]).

Fit the turbine casing (51000) back into the gas pipe.

Attach the cover plate (see following section).

Figure 40: Fitting the cover plate
Part number
51007
Table 42: Tightening torque (51007)
Make sure that the oil connections in the bracket are equipped with gaskets.

1. Close the opening in the turbine casing (51000) with the cover plate (01).
2. Thoroughly clean the fastening strips (51002) before assembly.
3. Coat the threads of the studs (51006) with high-temperature grease.
4. Fasten the cover plate on the turbine casing (51000) with fastening strips (51002), Verbus
Ripp® washers (51003) and nuts (51007), and screw it onto the bracket.
© Copyright 2016 ABB. All rights reserved.
TPS44
M8
30 Nm
HZTL4037_EN
TPS48
M8
30 Nm
Revision A
Page 87 / 99
TPS52
M10
60 Nm
August 2016