Wave Output Step Action Function - Mitsubishi Electric MELSEC iQ-R Series User Manual

Wave output step action function

This function changes addresses and data values to be output to change the analog output flexibly at any timing when the
wave output function is used.
This function is useful for the analog output test when the wave output function is used and for debugging the wave output
function.
Ex.
Wave output step action on the following conditions
• The output range is set to -10 to 10V.
• The wave output status is the wave output.
• The address of when the step action wave output request is accepted is 34990.
1 Set ON (1) to Step action wave output request (Un\G188) during the wave output.
(1) Set ON (1) to Step
action wave output
request (Un\G188).
1 FUNCTIONS
70
1.14 Wave Output Function
Address
Un\G25000
Un\G25001
Un\G25002
Un\G25003
Un\G34988
*1
Un\G34989
Current address
Un\G34990
Un\G34991
Un\G34992
Un\G34993
Un\G34994
Un\G34995
Un\G34996
Un\G34997
Un\G34998
Digital value
Analog output
0
(Digital input value)
1000
2000
10V
3000
5V
12000
14000
16000
18000
0V
20000
22000
24000
26000
28000
(2) The D/A converter module accepts
the request.
30000
32000
The update of the address to
be output stops.
*1 The contents described here is the case when the wave output status is the
wave output at the timing of (1). If the wave output status is the status other
than the wave output, following operations are performed at the timing of (2).
When the wave output status is the wave output stop
The digital input value of the address set as the wave pattern start
address is output in an analog value and held.
When the wave output status is the wave output pause
The data of the address during the wave output pause (wave output
current address) is held.
: Settings configured by a user
: Processing performed by the
D/A converter module
Analog output value
(2) The digital input value
(16000) of Un\G34990 is held.
*1
(1)