3.26.2 Instructions
1) Using the manufacturer's instructions supplied with the regulator, make
2) Apply Teflon
3) Insert the port one nipple on the filter/drain assembly into the output port on the
regulator and tighten the nut (see
4) Using the wiring instructions shown in
instructions enclosed with heater, make external connections.
Figure 3-53 ENC82S Filter/Drain Assembly Installation
2101510 Rev. AG
The technician responsible for installing the gas supply must
follow local and national codes.
external gas connections.
®
tape to the port one nipple on the filter/drain assembly.
The technician responsible for installing the power supply
must follow local and national codes.
Catalytic Heater Inlet
Add Filter/Drain Asm here
Regulator
Bracket/Tie Strap
Stopcock
Regulator
Vent Drain
Figure
3-53).
Figure 3-52
and the manufacturer's
Filter/Drain Kit
P/N: 2103855
Drain
(¼" NPT)
Customer Gas Inlet
(¼" NPT)
Page 3–51