Cabinet Mounting - Motorola SC 4812ET RF Hardware Installation Manual

Cabinet Mounting

– continued
Overview
Removing the Front Doors
(Optional)
4
68
This chapter covers the step–by–step instructions for mounting the RF
and Power Cabinet.
To facilitate the movement of the RF or Power Cabinet through
doorways or passageways with limited clearance, the front doors of the
cabinets can be removed. The procedure to do this is detailed in
Table 4-1.
Table 4-1: Procedure to Remove the Front Cabinet Doors (if required)
Step
1
2
3
4
5
6
SC 4812ET RF and Power Cabinet Hardware Installation Manual
TM
CAUTION
Do NOT lift or move the RF or Power Cabinet by the
doors, they will not support this type of loading and may
be damaged in the process.
WARNING
Do Not remove the front cabinet doors unless absolutely
required.
Open the primary front door.
Disconnect the Heat Exchanger Power and Alarm cables from
the Heat Exchanger.
For each hinge, loosen the screw that secures the door to the
hinge (See Figure 4-1).
Remove the windstay latch at the bottom of the door.
Lift the door straight up off the hinges.
! CAUTION
The front door of both the RF and Power Cabinet can weigh
up to 77 kg (170 lbs). Use extreme care when handling to
avoid damage to the door, heat exchanger, and gasket.
Repeat for the battery cabinet door of the Power Cabinet if
required.
DRAFT
Action
Apr 2001
V04.03