Dc Power Specifications; Gfci/Ac Outlet Specifications; Conduit I/O Plate Specifications - Motorola SC 4812ET RF Hardware Installation Manual

DC Power Specifications

GFCI/AC Outlet
Specifications

Conduit I/O Plate Specifications

Figure B-1: SC4812ET Conduit I/O Plates
RF Cabinet Conduit I/O Plate
1" Conduit
Knockouts (x6)
(Expansion, I/O,
Alarms, Other)
Apr 2001
SC
TM
V0B.03
The maximum total voltage drop between the RF and Power Cabinet (as
measured at the DC power connector in the I/O area of each cabinet)
must be less than or equal to 0.4V. The Power Cabinet is shipped with
Superflex #2/0 AWG cable, 12 ft. in length (See Chapter 2). Larger
diameter cable or other solutions, may be used to increase the distance
between cabinets provided the maximum voltage drop is not exceeded.
The Power Cabinet has two convenient GFCI/AC outlets, accessible
from the rear of the Power Cabinet. The circuit breaker of the outlets is
located in the Power Cabinet ACLC. The outlets are rated at a combinet
total of 15A @ 104 – 120 AC for the United States, Brazil, and Peru. In
addition there are five different outlets which can be configured and
tailored to different countries such as Argentina, China, Chile, Israel,
Hong Kong, Singapre, and the United Kingdom.
Removable I/O plates are provided for conduit termination on both the
RF and Power Cabinets. The panels for bottom entry are blank and can
be punched to accommodate various sized conduit, the rear entry panels
have knockouts sized for conduits as shown in Figure B-1. The bottom
and rear entry panels can be exchanged to allow for various
configurations.
s
PG11 Conduit 3" Conduit
Knockout Hole (DC)
(RGPS Fitting)
4812ET RF and Power Cabinet Hardware Installation Manual
NOTE
AC Power is not present in the SC4812ET RF Cabinet.
Power Cabinet Conduit I/O Plates
3" Conduit 1" Conduit Knockout
Hole (DC)
DRAFT
Cabinet Specifications
– continued
2" Conduit
(Pilot Beacon AC) Hole
(Main AC)
B
129