Motorola SC 4812ET RF Hardware Installation Manual page 62

How to Unpack the SC 4812ET BTS
– continued
How to Unpack a Cabinet
3
Unpack Procedure
62
Wood Shipping Crate
Use Table 3-1 to properly unpack the RF and Power Cabinet if the wood
shipping create was used.
Step
1
2
3
4
SC 4812ET RF and Power Cabinet Hardware Installation Manual
TM
WARNING
– The steel bands surrounding the carton can spring out
from the carton when the bands are cut. To avoid
personal injury, stand safely to the side of the bands
while cutting.
– A fully loaded RF Cabinet can weigh up to 635 Kg
(1400 lbs), and a Power Cabinet as shipped (without
the batteries installed) can weigh up to 544 kg (1200
lbs).
– If a cabinet is tipped more than 10 inches from
vertical, it is in danger of tipping over. Handle with
extreme caution to avoid tipping.
CAUTION
Do NOT lift or attempt to move the RF or Power Cabinet
by the doors, they will not support this type of loading and
may be damaged in the process.
Table 3-1:Unpacking a Cabinet (Wood Shipping Crate)
Inspect the crates and cartons for damage. (Refer to
Figure 3-3).
NOTE
It is recommended that two (2) people perform this procedure.
Loosen the latches on the bottom of the crate.
Remove the clips holding the top piece of wood, and remove
the top piece of the crate.
Remove the clips holding the side pieces of wood, and
remove the sides of the crate.
DRAFT
Action
. . . continued on next page
Apr 2001
V03.03