1-5-9. TM-57 Board
1. Remove the panel (U7) block assembly. (Refer to Section 1-3-2.)
2. Remove the panel (U2) block assembly. (Refer to Section 1-3-3.)
3. Remove the panel (U3). (Refer to Section 1-3-4.)
4. Disconnect the harness from the connector (CN2) on
the TM-57 board.
5. Remove the screw, then remove the TM-57 board.
6. To install, reverse the removal procedure.
1-6. Connecting the Power Cord
For connecting the power cord, refer to Section 1 in Installation Manual.
1-7. Replacing the Projection Lens
For replacing the projection lens, refer to Section 1 in Installation Manual.
1-8. Replacing the Lamp Bulb
For replacing the lamp bulb, refer to Section 1 in Installation Manual.
1-54 (E)
TM-57
board
PSW
4 x 10
CN2
Harness
Fig. 1-5-9
SRX-R320