ETP4830-A1 Embedded Power
User Manual
6.8.2 SMU01B and SMU01C
Set the following alarm parameters as required if you need to enable the alarm function or
modify the alarm severity and relay association.
Table 6-10 Alarm parameters for the SMU01B and SMU01C
Main
Menu
Settings
6.9 (Optional) Setting Communications Parameters
6.9.1 SMU01A
Setting Parameters Before Using WebUI
Before you use the WebUI to remotely manage the SMU01A, set the required IP parameters.
Procedure
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Issue 10 (2017-08-08)
Second-
Third-
Level
Level
Menu
Menu
Alarm
Alarm
Setting
Severity
Digital
Alarm
Relay Relate
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Fourth-
Default
Level
Value
Menu
AC Volt
Major
Low/High
NOTE
Take the AC
Over Volt
alarm as an
example.
Digital No. 1
NOTE
Take Digital No. 1 as an example.
Mode
High
AC Volt Low/High (Alarm)
NOTE
Take the AC Volt Low/High alarm as an
example.
Relate Relay
None
Default type
NC
6 Commissioning
Setting
Set the
parameter as
required.
Set the
parameter as
required.
Set the
parameter as
required.
Set the
parameter as
required.
36