ABB 650 series Engineering Manual page 39

1MRK 511 261-UEN -
650 series
Engineering Manual
substation. The organization structure for the IEDs may differ from the structure of
the primary equipment in the substation. In PCM600 it is possible to set up a
hierarchical structure of five levels for the IED identification.
Build up the plant structure according to the project requirements. PCM600 offers
several levels to build the hierarchical order from Center down to the IEDs in a bay.
The following levels are available:
1. Project = Center
2. Substation = Name of the substation
3. Voltage Level = identifies to which grid type or part in the substation the IED
belongs to
4. Bay = Bay within the voltage level
5. IED = selection of the IED, which is used in the bay. Several IEDs are possible
within a bay, for example one control IED and two protection IEDs.
IEC08000365 V2 EN
Figure 15: PCM600: Set up a plant structure
Once a plant structure is built the name of each level in the structure should be
renamed by the names/identifications used in the grid. Use the right mouse button
to build the plant structure by selecting the elements from the context menu.
Rename the level after insertion, using the Rename possibility or the Object
Properties. Figure 15 shows the start of a project with two IEDs placed but still not
renamed.
The plant structure corresponds to the complete grid including the
needed IEDs.
Procedure to build a plant structure:
Section 4
Setting up a project
IEC08000365-2-en.vsd
33